POCO X4 Pro 5G (Veux) Test Point

The POCO X4 Pro 5G (Veux) is a feature-packed smartphone, but like any device, it may run into software issues such as bootloops, FRP lock, or failure to boot. For such scenarios, the EDL (Emergency Download Mode), accessed via the Test Point method, is a reliable solution.

In this guide, we’ll show you how to locate the POCO X4 Pro 5G Test Point, use it to enter EDL Mode, and fix common problems effectively.

What is an EDL Test Point?

The EDL Test Point is a hardware feature on the device’s motherboard that allows it to enter Emergency Download Mode. This mode is crucial for:

• Flashing the stock firmware to unbrick the device.
• Bypassing FRP (Factory Reset Protection) locks.
• Fixing boot issues.

The POCO X4 Pro 5G Test Point is specifically compatible with these device variants:

• 2201116PG

When Should You Use the Test Point Method?

The EDL Point POCO X4 Pro 5G Test Point is helpful in these situations:

1. Your device is bricked and unresponsive.
2. Fastboot or Recovery Mode doesn’t work.
3. You need to bypass FRP locks.
4. Firmware flashing requires forced EDL Mode access.

Tools and Requirements

Before proceeding, ensure you have the following tools and files ready:

Tools and Equipment:

1. POCO X4 Pro 5G (Veux) device.
2. Precision screwdriver for opening the back cover.
3. Tweezers or a conductive tool to short the Test Points.
4. USB cable and a computer with Qualcomm USB drivers installed.
5. Flash tools like Mi Flash Tool or QFIL.
6. The appropriate stock firmware for your device variant (2201116PG).

Steps to Access EDL Mode Using Test Point

1. Power Off the Device

• Turn off the phone completely. If it’s stuck, press and hold the power button until it shuts down.

2. Disassemble the Phone

• Use a plastic pry tool to carefully remove the back cover.
• Unscrew the protective shield over the motherboard.

3. Locate the Test Points

• Identify the EDL Point veux Test Point on the motherboard.
• These are typically located near the battery connector or other key areas on the board.
• Refer to the image below for precise placement (Insert Picture Here).

4. Short the Test Points

• Use tweezers or a conductive tool to short the Test Points.
• While holding the Test Points shorted, connect the phone to your PC using a USB cable.

5. Verify EDL Mode

• On your computer, open Device Manager to confirm the device is detected as Qualcomm HS-USB QDLoader 9008.

6. Flash Firmware or Perform Repairs

• Use tools like Mi Flash Tool or QFIL to flash the stock firmware or bypass FRP locks.

Important Notes

1. Use Correct Firmware

   • Download firmware that matches your specific device variant (2201116PG) to avoid compatibility issues.

2. Handle with Care

   • Be gentle while opening the device and working on the motherboard to avoid damaging components.

3. Battery Charge

   • Ensure the battery is at least 50% charged to prevent interruptions during the flashing process.

4. Install Drivers

   • Make sure you’ve installed Qualcomm USB drivers on your PC for proper recognition in EDL Mode.

Topic Covered:

1. EDL Point POCO X4 Pro 5G Test Point
2. EDL Point veux Test Point
3. EDL Point 2201116PG Test Point

Conclusion

The POCO X4 Pro 5G (Veux) Test Point is a reliable solution for resolving software issues such as bricked devices, FRP locks, or firmware problems. By following this step-by-step guide and using the provided images, you can safely access EDL Mode and perform necessary repairs on your phone.

Always handle your device with care and ensure you have the correct tools and firmware for a smooth repair process. With this guide, troubleshooting your POCO X4 Pro 5G becomes easy and effective.