POCO M2 Pro (Gram) Test Point

The POCO M2 Pro (Gram) is a feature-packed smartphone, but like any device, it can encounter issues such as bootloops, FRP locks, or software corruption. In such situations, entering EDL (Emergency Download Mode) using the Test Point method becomes essential for troubleshooting and recovery.

This guide will help you locate the POCO M2 Pro Test Point, enter EDL Mode, and use it to flash firmware or remove FRP locks.

What is the Test Point Method?

The Test Point method involves shorting specific points on the motherboard to force the phone into Emergency Download Mode (EDL). This mode allows you to communicate with the phone at a hardware level using flashing tools, enabling repairs such as:

• Resolving bootloop or bricking issues.
• Flashing stock firmware.
• Bypassing FRP locks.

For the POCO M2 Pro (Gram), the Test Point method works seamlessly across all variants, including M2003J6CI.

Why Do You Need the Test Point Method?

The Test Point method is particularly useful when:

1. The phone does not boot or is stuck in a bootloop.
2. Fastboot or Recovery modes are inaccessible.
3. You need to flash stock ROM or remove an FRP lock.

Tools Required

To perform the Test Point method, you’ll need:

1. POCO M2 Pro (Gram) smartphone.
2. Precision screwdriver to open the back panel.
3. Tweezers or a conductive tool to short the Test Points.
4. USB cable and a PC with Qualcomm USB drivers installed.
5. Flash tools such as Mi Flash Tool or QFIL.
6. Stock firmware for the M2003J6CI variant.

Steps to Access EDL Mode via Test Point

1. Power Off the Device

• Ensure the phone is completely turned off. If it’s stuck, hold the power button until it shuts down.

2. Disassemble the Phone

• Use a pry tool to carefully remove the back cover of the device.
• Unscrew and remove the protective cover over the motherboard.

3. Locate the Test Points

• Find the EDL Point POCO M2 Pro Test Point on the motherboard. These points are usually located near the battery connector or other critical components.
• Refer to the image below for the exact location (Insert Picture Here).

4. Short the Test Points

• Use tweezers or a conductive tool to short the identified Test Points.
• While holding the Test Points shorted, connect the phone to your PC using a USB cable.

5. Verify EDL Mode

• Open Device Manager on your PC to check if the device is recognized as Qualcomm HS-USB QDLoader 9008.

6. Flash Firmware or Remove FRP Lock

• Launch Mi Flash Tool or QFIL to flash the stock firmware or remove the FRP lock.

Key Points to Remember

1. Firmware Compatibility

   • Always use the correct firmware version for your device variant (M2003J6CI) to avoid bricking the phone.

2. Battery Charge

   • Ensure the battery is at least 50% charged before performing any flashing operations.

3. Driver Installation

   • Install Qualcomm USB drivers to ensure the phone is recognized in EDL Mode.

4. Handle with Care

   • Be cautious while opening the device and shorting the Test Points to avoid damaging internal components.

Topic Covered:

1. EDL Point POCO M2 Pro Test Point
2. EDL Point gram Test Point
3. EDL Point M2003J6CI Test Point

Conclusion

The POCO M2 Pro (Gram) Test Point is a vital tool for troubleshooting issues like bootloops, FRP locks, and software corruption. By following this guide and using the suggested images, you can safely access EDL Mode and resolve these problems.

Always ensure you have the correct firmware and tools before proceeding. If done correctly, the Test Point method is an effective way to recover your POCO M2 Pro and restore it to working condition.