How to Fix Realme C53 Stuck on Logo After Unlock in UMT

If you've recently unlocked your Realme C53 using the UMT tool and found your device stuck on the logo screen, don't worry—this issue is common and fixable! In this article, we'll guide you through a step-by-step process to resolve this problem using the SPD Tool and Flash File.

Why Does Realme C53 Get Stuck on Logo After UMT Unlock?

When unlocking a phone using UMT (Ultimate Multi Tool), the formatting process can sometimes disrupt the device’s system files. This results in the phone being unable to boot past the logo screen. The solution involves re-flashing the correct firmware to restore your device.

What You’ll Need

To fix this issue, you will require the following tools and files:

1. SPD Flash Tool (Spreadtrum Flash Tool)

2. Realme C53 Flash File (Use RMX3762export_14_C.13_20240805172935 Stock Firmware)

3. USB Drivers (SPD Drivers for proper device detection)

4. A Windows PC

5. A USB Cable

6. WinRAR (for Extract Zip file)

Step-by-Step Guide to Fix Realme C53 Stuck on Logo

Follow these steps carefully to restore your phone:

Step 1: Download the Required Tools

1. Download the SPD Flash Tool, Flash File for Realme C53, and SPD USB Drivers from above provided trusted link.

2. Install the SPD USB Drivers on your PC to ensure your phone is detected during the process.

Step 2: Extract the Flash File

1. Extract the downloaded Flash File to a folder on your PC.

2. Make sure you can locate the .pac file, as it will be used during the flashing process.

Step 3: Launch the SPD Flash Tool

1. Open the SPD Flash Tool folder and run the application as an administrator.

2. In the tool interface, click on the "Load Packet" button and select the extracted .pac file.

Step 4: Connect Your Realme C53

1. Turn off your Realme C53.

2. Press and hold the Volume Down + Volume Up buttons and connect your phone to the PC using a USB cable.

3. The tool should detect your phone automatically.

Step 5: Start the Flashing Process

1. Once your phone is detected, click on the "Start" button in the SPD Flash Tool.

2. The tool will begin flashing the firmware to your device.

3. Wait for the process to complete—this may take a few minutes.

Step 6: Reboot Your Device

1. After the flashing process is complete, disconnect your phone from the PC.

2. Turn on your Realme C53. It should now boot up normally without being stuck on the logo screen.

Troubleshooting Tips

If you encounter any issues during the process, here are some solutions:

1. Phone Not Detected: Ensure the SPD drivers are installed correctly and try using a different USB cable or port.

2. Flashing Process Fails: Double-check that you’ve selected the correct .pac file for your device model.

3. Device Still Stuck on Logo: Repeat the flashing process to ensure the firmware is properly installed.

Minimum Requirements for Flashing

• Ensure your phone has at least 50% battery to avoid interruptions during the process.
• Use a reliable PC to prevent any crashes or errors while flashing.

Video Tutorial

Conclusion

By following this guide, you can easily fix the Realme C53 stuck-on-logo issue after UMT unlock. Remember to use the correct tools and firmware to avoid further complications. If you found this article helpful, feel free to share it with others facing similar issues. For more tips and guides, stay tuned!

Keywords for SEO: Realme C53 stuck on logo, Realme C53 bootloop fix, SPD Tool guide, Realme C53 firmware flashing, UMT unlock fix, Realme C53 troubleshooting.