Enabling VoLTE (Voice over LTE) on your Samsung Galaxy J4 SM-J400F can significantly enhance your call quality by using your LTE network for voice calls instead of just data. Follow these detailed steps to flash the necessary firmware using Odin and enable VoLTE on your device.
Prerequisites
Before you begin, make sure you have the following:
- Samsung Galaxy J4 SM-J400F device with good battery charged do not try with low battery
- Samsung Galaxy J4 SM-J400F VoLTE firmware | Mirror
- Samsung Galaxy J4 SM-J400F USB Driver
- Samsung Galaxy J4 SM-J400F Odin flash tool
- Micro USB cable with good quality
- Computer or Laptop
Step-by-Step Procedure
1. Download Firmware and Odin Flash Tool
- Download the tested firmware and Odin flash tool from the provided link.
2. Extract Files
- Extract the downloaded files to your desktop or a preferred location. Ensure WinRAR is installed on your computer to extract the files.
3. Open Odin Flash Tool
- Navigate to the extracted Odin3_v3.13.1 folder and open the Odin3_v3.13.1.exe file.
4. Load Firmware Files into Odin
- Click the BL button and select the BL_J400FXXU2ARH5_CL13992505_QB19574257_REV00_user_low_ship.tar.md5 file.
- Click the AP button and select the AP_J400FXXU2ARH5_CL13992505_QB19574257_REV00_user_low_ship_meta.tar.md5 file.
- Click the CP button and select the CP_J400FXXU2ARG8_CP10173665_CL13992505_QB18946388_REV00_user_low_ship.tar.md5 file.
- Click the CSC button and select the HOME_CSC_OMC_ODM_J400FODM2ARH4_CL13992505_QB19548864_REV00_user_low_ship.tar.md5 file.
5. Adjust Odin Settings
- In Odin, go to the Options tab and uncheck the "Auto Reboot" option.
6. Prepare Your Device
- Turn off your Samsung Galaxy J4 if it is currently on.
- Press and hold the Volume Down + Home + Power buttons simultaneously to boot the device into Download Mode.
7. Connect Your Device
- Connect your Samsung Galaxy J4 to your computer using a USB cable. Wait until the necessary drivers are installed.
8. Start the Flashing Process
- Click the Start button in Odin to begin the firmware installation process. Do not disconnect your device during this process.
9. Complete the Flashing Process
- Wait until the firmware is fully installed. Your device will remain in Download Mode until the process is complete.
10. Perform a Hard Reset
- Remove the battery from your device and then reinsert it.
- Press and hold the Volume Up + Home + Power buttons until the Samsung logo appears, then release only the Power button while continuing to hold the Volume Up + Home buttons until the Recovery Menu appears.
11. Wipe Data and Reboot
- In the Recovery Menu, select the "Wipe data/factory reset" option.
- After the reset is complete, choose the "Reboot system now" option.
Conclusion
Congratulations! You have successfully enabled VoLTE on your Samsung Galaxy J4 SM-J400F. By following these steps, you can enjoy improved call quality and better connectivity using your LTE network for voice calls.
Feel free to reach out if you encounter any issues or need further assistance. Happy calling!
No comments:
Post a Comment
Write Your Problem in the Below Comment Box